E7 – Speed Stall Error

OVERVIEW

If no belt movement is detected several seconds after commanding belt movement a speed stall error (E7) is called.

Step 1 :

E7 Error

Enter firmware setup screen

Start PWM 1/2MAX test

N

Belt Moving

Y

Allow belt speed to stabilize and measure belt speed

Measured speed different than

Y

 

displayed speed

 

N

 

Measured speed = 6.4

N

 

MPH

 

Y

 

Displayed speed = 0

N

 

Y

 

Speed feedback missing

 

Belt drive issue

Speed Feedback Issue

AUTO CALIBRATION

AUTO CALIBRATION

Step 2 :

Belt Drive Issues – See belt drive issue trouble shooting section in the CORRECTIVE ACTION PROCEDURES – Speed Issues section of this document.

Speed Feedback Issues – See speed feedback issue trouble shooting section in the CORRECTIVE ACTION PROCEDURES – Speed issues section of this document.

Speed Feedback Missing Issues – See speed feedback issue trouble shooting section in the CORRECTIVE ACTION PROCEDURES – Speed Issues section of this document.

Calibration Issues – See speed calibration issue trouble shooting section in the 37 CORRECTIVE ACTION PROCEDURES – Speed Issues section of this document

Page 37
Image 37
Miele T9800HRT service manual E7 Speed Stall Error