Miele T 7634 operating instructions Changing water conductivity setting, Important condition

Programmable functions

Changing water conductivity setting

￿This programmable function should be adjusted only when residual water content is erroneously determined owing to the extreme softness of the water.

Important condition

The water in which fabrics are washed may be extremely soft with a conductivity value less than 150 μS/cm. Drinking water conductivity can be ascertained from your local water supplier.

Activate this programmable function only if the above-mentioned condition applies.

Otherwise the drying result will be unsatisfactory.

For programming and saving in memory, follow steps ￿ to ￿.

The function is programmed using the buttons.

Precondition:

–The dryer is switched off.

–The door is closed.

￿Press Start/Stop and keep it pressed it during steps ￿-￿.

￿Press the I-On/0-Offbutton in.

Wait until the Start/Stop button lights up continuously . . .

￿. . . then release the Start/Stop button.

￿Press the Gentle button six times.

–The Gentle indicator light flashes once slowly and twice briefly.

–P and 0 flash alternatingly in the display (default setting).

The number appearing alternatingly with P means:

0Default setting

ILower conductivity setting

(Express indicator light also flashes)

￿Pressing the Start/Stop button switches from one to the other.

￿Using the I-On/0-Offbutton, switch the dryer off.

The programming is now stored in memory. You can change it again at any time.

51