Adjusting the dryer's
electronics for very soft water
,In some areas of the UK, water is
extremely soft which can affect the
sensitivity of the control electronics.
If the dryer is installed in an area
with very soft water, you should
contact your local water supplier for
information and advice regarding
water hardness and water
conductivity. If the water
conductivity is less than 150 µS, the
following programmable function will
need to be activated.
Important. This programmable
function should not be activated if,
despite the water being extremely
soft (as would be the case if a water
softener were used), its conductivity
is greater than 150 µS.
Follow steps Ato Fto programme
and store in memory.
Before you begin, first ensure that:
–The tumble dryer is switched off.
–The door is closed.
APress the Start/Stop button and keep
it pressed in whilst carrying out steps
B-C.
BPress the I-On/0-Off button in.
Wait until the indicator light for the
Start/Stop button lights up
constantly ...
C. . . and then release the Start/Stop
button.
DPress the Low temperature button six
times.
–The Low temperature indicator light
will flash on and off slowly once and
will then flash on and off quickly
twice.
–Pand 0(default setting) will flash
alternately in the display.
The number which appears alternately
in the display with Pmeans:
0Default setting
iAdjusted for very soft water
(with low conductivity)
(The Automatic indicator light will
also flash)
EPressing the Start/Stop button
switches from one to the other.
FSwitch the dryer off with the
I-On/0-Off button.
The setting you have selected is now
stored in memory. You can change it
again at any time.
Programmable functions
51