Command Line Interface

4-28

4
Example
Related Commands
enable (4-20)
IP Filter Commands

management

This command specifies the client IP addresses that are allowed management
access to the switch through various protocols. Use the no form to restore the
default setting.
Syntax
[no]management {all-client | http-client | snmp-client | telnet-client}
start-address [end-address]
•all-client - Adds IP address(es) to the SNMP, Web and Telnet groups.
• http-client - Adds IP address(es) to the Web group.
• snmp-client - Adds IP address(es) to the SNMP group.
•telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
Command Usage
• If anyone tries to access a management interface on the switch from an invalid
address, the switch will reject the connection, enter an event message in the
system log, and send a trap message to the trap manager.
• IP address can be configured for SNMP, Web and Telnet access respectively.
Each of these groups can include up to five different sets of addresses, either
individual addresses or address ranges.
Console(config)#enable password level 15 0 admin
Console(config)#
Table4-11 IP Filter Commands
Command Function Mode Page
management Configures IP addresses that are allowed management access GC 4-28
show management Displays the switch to be monitored or configured from a
browser
PE 4-29