Safety Compliance
Warning: Fiber Optic Port Safety
| When using a fiber optic port, never look at the transmit laser while it is |
CLASS I | powered on. Also, never look directly at the fiber TX port and fiber cable |
LASER DEVICE | ends when they are powered on. |
|
Avertissment: Ports pour fibres optiques - sécurité sur le plan optique
DISPOSITIF LASER | Ne regardez jamais le laser tant qu'il est sous tension. Ne regardez |
jamais directement le port TX (Transmission) à fibres optiques et les | |
DE CLASSE I | embouts de câbles à fibres optiques tant qu'ils sont sous tension. |
|
Warnhinweis: Faseroptikanschlüsse - Optische Sicherheit
LASERGERÄT DER KLASSE I
Niemals ein Übertragungslaser betrachten, während dieses eingeschaltet ist. Niemals direkt auf den
Please read the following safety information carefully before installing the switch:
WARNING: Installation and removal of the unit must be carried out by qualified personnel only.
•The unit must be connected to an earthed (grounded) outlet to comply with international safety standards.
•Do not connect the unit to an A.C. outlet (power supply) without an earth (ground) connection.
•The appliance coupler (the connector to the unit and not the wall plug) must have a configuration for mating with an EN 60320/IEC 320 appliance inlet.
•The socket outlet must be near to the unit and easily accessible. You can only remove power from the unit by disconnecting the power cord from the outlet.
•This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC 60950. The conditions are only maintained if the equipment to which it is connected also operates under SELV conditions.
France and Peru only
This unit cannot be powered from IT† supplies. If your supplies are of IT type, this unit must be powered by 230 V (2P+T) via an isolation transformer ratio 1:1, with the secondary connection point labelled Neutral, connected directly to earth (ground).
†Impédance à la terre
•
iv
