6.

Troubleshooting

This section is intended to help you solve some common problems encountered while using the MIL-SME801P switch series.

Incorrect connections

The RJ-45 port will auto-detect the signal configuration of the cable. For 10/100 Mbps, only two pairs of wires are required for communications. For 1000Base-TX, all four pairs of wire are required. Some cabling plants may not have all four pairs, causing a fault in the link.

The fiber port is either a multi-mode or single-mode fiber type. Ensure that the fiber in the cable matches that of the fiber port.

„Faulty or loose cables

Look for loose or obviously faulty connections. If they appear to be OK, make sure the connections are snug. If that does not correct the problem, try different cables.

„Non-standard cables

Non-standard and miss-wired cables may cause numerous network collisions and other network problem. This can seriously impair network performance. A category 5 cable tester is a recommended tool for every network installation.

143

Page 149
Image 149
Milan Technology MIL-SME801GSX, MIL-SME801P manual Incorrect connections, „ Faulty or loose cables, „ Non-standard cables