Wrapper Removal, Turn Off | Miller Electric ICE-27T, 375 X-TREME

.A complete Parts List is available at www.MillerWelds.com

6-3. Wrapper Removal

	Y Turn		off	power,	and
		disconnect input power plug
		from	receptacle		before
		working on unit.
	Y Significant DC voltage can
		remain on capacitors after unit
2		is Off. Wait until all front panel
		LED’s are off before removing
		wrapper.
1	Y Check		DC	bus	voltage
		according to Section 6-4after

		removing wrapper.
	1	Wrapper
	2 Torx Screws (Fine Thread)

Remove Torx screws and slide wrapper off.

Tools Needed:

Torx 25

Ref. 804 505-A

OM-225 216 Page 19

Page 23

Image 23

Miller Electric ICE-27T Wrapper Removal, Turn Off, Wrapper Check Bus, Removing wrapper Wrapper Torx Screws Fine Thread

Contents

File Plasma Cutters OM-225 216FProcesses Description From Miller to You Table of Contents Page Cutting can cause fire or explosion Symbol UsageMarks a special safety message Plasma Arc Cutting Hazards Noise can damage hearing Exploding Parts can injureFlying Sparks can cause injury ARC Rays can burn eyes and skin California Proposition 65 Warnings About Pacemakers Principal Safety StandardsEMF Information Identifie un message de sécurité particulier Signification des symbolesLE Coupage présente un risque de feu ou d’explosion UNE Décharge Électrique peut entraîner la mort LE Plasma D’ARC peut entraîner des blessures Risque de blessure en casLE Bruit peut endommager l’ouïe LES Fumées ET LES GAZ peuvent être dangereux Risque D’INCENDIE OU DES Pieces Chaudes peuvent pro- voquer des brûlures gravesDES Organes Mobiles peuvent provoquer des blessures LA Chute DE L’APPAREIL peut blesser Consignes relatives aux stimulateurs cardiaques Principales normes de sécuritéInformation sur les champs électromagnétiques LE Coupage Ã L’ARC peut causer des interférence Specifications For Torch Symbols And DefinitionsSpecifications Duty Cycle And Overheating Power Source Dimensions And WeightTorch Dimensions And Weight Connecting Work Clamp Connecting Gas/Air Supply Input Voltage 240 Input Amperes At Rated Output Electrical Service Guide For 240 VACExtension Cord Data 60 Hz Connecting 1-Phase Input Power For 240 VAC 460 mm Connecting Input Power Controls − Operation Cutting Speed Trigger Safety Lock Pilot arc starts immediately When trigger is pressedSequence Of Operation Example Of Cutting Operation Overload Protection Routine Maintenance Removing wrapper Wrapper Torx Screws Fine Thread Wrapper RemovalTurn Off Wrapper Check Bus DC Bus Voltage Check Checking Or Replacing Filter Element Shield Cup Checking Torch Shield Cup Shutdown System Checking/Replacing Retaining Cup, Tip, And Electrode Turn Off power source before checking torch parts Work Cable Connections Torch And Work Cable ConnectionsTorch Connections OM-225 216 − Electrical Diagram 224 682-B Recommended Spare Parts Recommended Spare Parts OM-225 216 Page Support Service Miller Electric Mfg. Co Owner’s Record

Miller Electric ICE-27T, 375 X-TREME manual Wrapper Removal, Turn Off, Wrapper Check Bus

Models: 375 X-TREME ICE-27T

6-3. Wrapper Removal

Y Turn

off

wrapper.

Y Check

bus

removing wrapper.

Wrapper

2 Torx Screws (Fine Thread)