Checking Or Replacing Filter Element | Miller Electric ICE-27T

.A complete Parts List is available at www.MillerWelds.com

6-5. Checking Or Replacing Filter Element

Y Check DC bus voltage according to Section 6-4,and be sure voltage is near zero before touching any parts.

Turn power Off, and disconnect input power plug from receptacle. Remove wrapper from unit (see Section 6-3).

1 Filter Base

2 Filter

3 Filter Cup

Unscrew filter cup from base.

Remove cup.

Unscrew filter element from base.

Check filter element for dirt and moisture, and replace if necessary.

Be sure that all parts are clean and dry.

Reinstall filter element, and secure filter cup.

Reinstall wrapper.

Tools Needed:

Torx 25

804 506-B

OM-225 216 Page 21

Page 25

Image 25

Miller Electric ICE-27T, 375 X-TREME manual Checking Or Replacing Filter Element

Contents

Processes OM-225 216FDescription File Plasma Cutters From Miller to You Table of Contents Page Marks a special safety message Symbol UsagePlasma Arc Cutting Hazards Cutting can cause fire or explosion Flying Sparks can cause injury Exploding Parts can injureARC Rays can burn eyes and skin Noise can damage hearing California Proposition 65 Warnings EMF Information Principal Safety StandardsAbout Pacemakers LE Coupage présente un risque de feu ou d’explosion Signification des symbolesUNE Décharge Électrique peut entraîner la mort Identifie un message de sécurité particulier LE Bruit peut endommager l’ouïe Risque de blessure en casLES Fumées ET LES GAZ peuvent être dangereux LE Plasma D’ARC peut entraîner des blessures DES Organes Mobiles peuvent provoquer des blessures DES Pieces Chaudes peuvent pro- voquer des brûlures gravesLA Chute DE L’APPAREIL peut blesser Risque D’INCENDIE OU Information sur les champs électromagnétiques Principales normes de sécuritéLE Coupage Ã L’ARC peut causer des interférence Consignes relatives aux stimulateurs cardiaques Specifications Symbols And DefinitionsSpecifications For Torch Torch Dimensions And Weight Power Source Dimensions And WeightDuty Cycle And Overheating Connecting Work Clamp Connecting Gas/Air Supply Extension Cord Data Electrical Service Guide For 240 VAC60 Hz Input Voltage 240 Input Amperes At Rated Output Connecting 1-Phase Input Power For 240 VAC 460 mm Connecting Input Power Controls − Operation Cutting Speed Trigger Safety Lock Sequence Of Operation When trigger is pressedExample Of Cutting Operation Pilot arc starts immediately Overload Protection Routine Maintenance Turn Off Wrapper RemovalWrapper Check Bus Removing wrapper Wrapper Torx Screws Fine Thread DC Bus Voltage Check Checking Or Replacing Filter Element Shield Cup Checking Torch Shield Cup Shutdown System Checking/Replacing Retaining Cup, Tip, And Electrode Turn Off power source before checking torch parts Torch Connections Torch And Work Cable ConnectionsWork Cable Connections OM-225 216 − Electrical Diagram 224 682-B Recommended Spare Parts Recommended Spare Parts OM-225 216 Page Support Service Miller Electric Mfg. Co Owner’s Record