3
Installing Paper Rolls
Precaution: The paper cutter is mounted on the printer cover. Take caution when removing and installing the cover.
The register can print receipts and journals. For the printer, you must install the paper rolls (receipt and journal paper rolls) provided with the register.
Install the paper rolls according to the procedure shown below with the power cord connected and the mode switch set to the REG position:
1.Cut off approximately one revolution of each paper roll. Make sure each paper end is cut as per the diagram.
| Correct | Incorrect |
2. Lift up the print roller release lever | Print roller release lever |
|
(indicated as "PULL" on it) of the | (Receipt side) |
|
receipt side to unlock and open the |
|
|
print roller arm. |
|
|
| Print roller arm |
|
| (Receipt side) |
|
3.Set a paper roll in the paper roll cradle of the receipt side as
per the diagram.
To the printer | To the printer |
Correct | Incorrect |
4. Feed the end of the paper along with |
|
the paper positioning guides as per |
|
the diagram. |
|
Paper positioning guides |
|
5.While holding down the paper, slowly close the print roller arm of the receipt side, and push down the
of the arm until you hear a click locking the arm. Make sure securely you push down the center of the wing part of the arm as per the diagram. The paper will be fed automatically.
If the print roller arm is not securely locked, printing is not done right. If this problem occurs, open the
10arm, and close the arm as instructed above.
