Sharp XE-A303 instruction manual Initializing the Cash Register, Part1 QUICK START GUIDE

Part1 QUICK START GUIDE Part2 Part3

2

Initializing the Cash Register

In order to operate the cash register properly, you must initialize it before operating for the first time. Follow this procedure.

1.Make sure the power cord plug is not inserted into the AC outlet.

2.Insert the manager (MA) key into the mode switch and turn it to the PGM position.

3.While holding down both the }key and the lkey, insert the plug into the AC outlet. The buzzer will sound three times and “??? MRS. ???”

will be displayed.

4.The cash register has now been initialized. The register display will now show “0.00” with “PGM”.

REG

OPX/Z MGR

X1/Z1

X2/Z2

PGM

*** MRS. ***

_

PGM 0.00

If the buzzer does not sound when the plug is inserted, the initialization has not been done successfully. (This will occur when the voltage is high because you operated the cash register before starting initialization.) Wait at least ten seconds after pulling out the plug and initialize the cash register again.

The cash register has a built-in memory protection circuit which is operated by rechargeable batteries. Since the rechargeable batteries have been discharged, please charge the batteries for one or two days before using the cash register for the first time. To charge the batteries, set the mode switch to a position other than “ ” with the power cord plugged into the AC outlet.

Unless the batteries have been charged, all of the programmed data and sales data is not saved.

If you press a key by mistake, an error message such as “HEAD UP” or “PAPER EMPTY” may be displayed. Press the lkey to clear message after installing paper rolls.

9