Sharp XE-A303 instruction manual Wg W H hijk N01, Guidance for text programming, ABCD 01 Wa1

Part1 QUICK START GUIDE Part2 Part3

Guidance for text programming

The register allow you to program texts for department item names (page 16), PLU/subdepartment item names (page 22), function texts (page 65), clerk names (page 25), logo messages (page 25), foreign and domestic currency symbols (page 64), and training mode texts (page 65).

There are two ways for programming text; using character keys on the keyboard or entering character codes with numeric keys on the keyboard. For the latter way, refer to "Entering character codes with numeric keys on the keyboard" on page 50.

Using character keys on the keyboard

You can enter characters according to the small figures printed in the lower right position of the tops. For the layout, please refer to “Keyboard” section on page 6.

The following are used as control keys for character entry:

HToggles between upper-case and lower-case letters. By default, the upper-case letter is selected. Once the Hkey is pressed, you are locked in for entering lower-case letters. “a” is displayed when lower- case letters entry is selected as shown in the operator display example below.

NPress the Nkey to enter numeric characters. For example to enter “1”, press the Nand 1key. If you press the 1key without pressing the Nkey, the cash register goes to character codes entry mode.

Once the Nkey is pressed, you are locked in for entering numeric characters. "1" is displayed when numeric characters entry is selected.

WToggles between single-size and double-size characters. By default, the single-size character is selected. Once the Wkey is pressed, you are locked in for entering double size characters. “W” is displayed when double-size characters entry is selected as shown in the operator display example below.

BBacks up the cursor, erasing the character to the left.

Operator display (Example) Cursor

ABCD_

01 Wa1 032

Character code

Department code, PLU code, function number,

clerk code or logo message line number is displayed here.

Characters entered using character keys is displayed here.

To program the word “Clerk01” with the letter “C” being double size.

To make the letter “C” double size character

To make character size return to normal size

To toggle the characters to lower-case letters

To enter numbers

Wg

W

H

hijk

N01

=C	_
01		W			032
=C	_
01					032
=C	_
01			a		032
=Clerk		_
01			a		032
=Clerk01				_
01			a1		032

13