4-2. Adjusting Control Tilt Bracket
1 Tilt Bracket
2 Rear Pivot Screw
3 Front Screw
Loosen rear pivot screw. Remove front screw. Pivot control down- ward to desired viewing angle. Re- place and tighten front screw. Tight- en pivot screw.
1
2
3
803 155
4-3. Installing Boom And Reel Support
3
7
4
5
2
6
1
1Swivel Plates
2Yoke
Remove hardware from swivel plates and yoke.
3 Boom
Set boom into swivel as shown.
4 Yoke Pin
Install pin through yoke. Install cot- ter pin and spread ends.
5 Bolt
Install bolt, tighten hardware, and back bolt off one half turn.
6 Locking Knob
Install locking knob but do not tighten.
7Reel Support Install reel support.
Tools Needed: 3/8, 3/4 in
