4-8. Air-Cooled Feeder Connections
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
2 |
| 4 | 6 | 7 | 3 | |||
47
8
Rear Panel
Top View
1
1Gas Hose Grommet
210 ft (3 m) Gas Hose
3Rear Of Gas Fitting
Route one end of gas hose through grommet, and connect hose to rear of Gas fitting in feeder. Connect remaining end of hose to regulator/flowmeter.
4Weld Cable To Welding Power Source
Select and prepare weld cable ac- cording to welding power source manual.
5Weld Cable Grommet
6Current Sensing (Reed) Relay
7Weld Cable Terminal In Feeder
Route one end of weld cable through grommet, through reed relay, and connect to weld cable terminal in feeder. Connect remaining end of cable to positive
(+)weld output terminal on welding power source.
8 Gun Weld Cable
Be sure that terminal of welding power source weld cable is in direct contact with terminal from gun weld cable. Close and latch door.
Connect To | 5 |
|
| |
Positive (+) Weld | Connect To | Tools Needed: | ||
| ||||
Output Terminal On |
| Regulator/ |
| |
Welding Power Source |
| Flowmeter | 5/8, |
Ref. 151
