Miller Electric XR W, XR A manual Operation, Front Panel Controls Of Feeder Air-Cooled Model Shown

SECTION 5 − OPERATION

5-1. Front Panel Controls Of Feeder (Air-Cooled Model Shown)

		1	Voltage/Wire Speed Meter
	1		(Optional)
		2	Voltage/Wire Speed Switch
	2		(Optional)
	3	3	Run-In Speed Control
		4	Jog Switch
	4	5	Burnback Time Control
			(Optional)
11	5	6	Spot/Continuous Switch
			(Optional)
	6	7	Remote Voltage Control
			(Optional)
	7	8	Power Switch
10		9	Time Range Switch (Optional)
9		10	Spot Time Control (Optional)
	8	11	Flowmeter (Optional)

				151 780−A
5-2. Safety Equipment
1	2	3	Wear the following while welding:
			1	Dry, Insulating Gloves
			2	Safety Glasses With Side
				Shields
			3	Welding Helmet With Correct
				Shade Of Filter (See ANSI
				Z49.1)
				sb3.1 1/94
5-3. Work And Voltage Sensing Cable Clamps
			1	Work Clamp
			Connect work clamp to a clean,
	1		paint-free location on workpiece, as
			close to weld area as possible.
		2	Use wire brush or sandpaper to
			clean metal at weld joint area.
			2	Voltage Sensing Cable Clamp
			Connect voltage sensing cable
			clamp to workpiece for constant
Tools Needed:			current (CC) operations (see
			Section 4-10).

sb4.1* 2/93 − Ref. 144 451-A

OM-1581 Page 24