owners manual
FEATURES
Auto/On/Off
Your subwoofer is equipped with a special circuit that automatically turns your subwoofer on as soon as it senses a program signal. At a predetermined time after the signal ends, this circuit automatically turns the subwoofer off. The power switch must be set in the ON position to engage this circuit.
Once the subwoofer is plugged in and the power switch has been engaged, an LED on the control will illuminate and display a red light. This red light indicates the subwoofer is in standby mode. When the subwoofer receives a signal from the system, this light will turn green to indicate that it is playing. Once the system has been turned off, the sub will return to its standby mode after approximately 10 minutes and display the red light.
Overload Protection Circuit (OPC)
The MIRAGE Overload Protection Circuitry (OPC) protects the amplifier from being overdriven and the subwoofer from over excursion of the woofer cone thus ensuring years of safe and reliable performance.
Care of your Subwoofer
To maintain the beautiful finish on your new MIRAGE subwoofer, from time to time, gently wipe it down with a soft, damp cloth to remove any dust or stains.
During normal conditions, your new subwoofer can be left on continuously without any problems. However, if you plan to leave the subwoofer unused for an extended period of time, we recommend that you unplug it.
Trouble Shooting
Should you experience a problem with your subwoofer, here are some helpful suggestions to follow before you seek service.
•Verify that the subwoofer is plugged in and the power outlet is active.
•Verify that the power switch is on.
•Verify that the subwoofer is receiving an input signal from the source. This may involve testing your speaker wire or
•Check that the controls such as volume and crossover have been properly set.
•Verify the low level input you are using. Subwoofer controls are bypassed when using the Xover input.
•If the subwoofer remains on, even when the system is turned off, this is usually a sign that the wire being used is picking up an electrical signal from another wire or appliance. Try rerouting the wire or make sure you’re using a shielded cable.
The following conditions require service from a qualified technician:
•Damaged power cord.
•If the subwoofer does not appear to operate normally or exhibits a marked change in performance.
•The unit has been exposed to water.
•The cabinet or circuitry is physically damaged.
OM-200
System Type | Omnipolar Subwoofer |
Power Output | 800 watt dynamic peak, 200 watts continuous |
Woofer | 2 - 8” Polypropylene Titanium Deposit Hybrid |
Magnet Size | 28 oz. |
Voice Coil Diameter | 1.5” |
Frequency Response | |
Phase Control | Continuously variable from |
AV Switch | 0/+3db |
Variable Low Pass Filter | 40Hz |
Inputs | Low level input, crossover bypass, high level |
Outputs | High Level |
Dimensions | inches: |
| cm.: 41.3 x 47.4 x 42.5 |
Finish | Black High Gloss, Cherry |
Weight | 70 lbs. |
| 32 kg |
LIMITED WARRANTY POLICY
Warranty Outside of The United States and Canada:
Product warranties may be legislated differently from one country to another. Ask your local dealer for details of the LIMITED WARRANTY applicable in your country.
IMPORTANT: Please retain the carton and packing material for this MIRAGE product to protect it in the event it ever has to be shipped to a service center for repair. Product received damaged by a service center that has been shipped by the end user in other than the original packaging, will be repaired, refurbished and properly packaged for return shipment at the end user’s expense.
WARRANTY FOR UNITED STATES AND CANADA (see back cover)
5
