Mitsubishi 6G7 specifications 11A-7-3, Fa Intake Manifold, Gainjector, Ha Fuel Pressure Regulator

6G7 ENGINE (E - W) - Intake Manifold 11A-7-3

Front

7IN0090

7FU0611

Setting mark

Projection portion 6AE0062

"FA INTAKE MANIFOLD

(1)Tighten the nuts on the right bank to 5 - 8 Nm.

(2)Tighten the nuts on the left bank to the specified torque. Then tighten the nuts on right bank to the specified torque.

(3)Tighten the nuts on the left bank and those on the right bank again in that order.

"GAINJECTOR

(1)Apply a small amount of engine oil to the O-ring.

Caution

D Take care to prevent the engine oil from entering the delivery pipe.

(2)Install the injector into the delivery pipe and turn it right and left.

(3)Make sure the injector turns smoothly. If not, the O-ring may be caught. Remove the injector and check for damage to the O-ring, then re-insert it and confirm that it turns smoothly.

(4)When installing the injector, set the delivery pipe setting mark and the injector projecting portion.

"HA FUEL PRESSURE REGULATOR

(1)Apply a small amount of new engine oil to the O-ring, then insert the fuel pressure regulator into the delivery pipe, taking care not to damage the O-ring.

Caution

D Take care to prevent engine oil from entering the delivery pipe.

(2)Make sure the regulator turns smoothly. If not, the O-ring may be caught. Remove the regulator and check for damage to the O-ring, then re-insert it into the delivery pipe and confirm that it turns smoothly.

E Mitsubishi Motors Corporation Dec. 1996 PWEE9615