Preparing your projector

Checking accessories

The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in the package.

Cables

 

Power supply part

Mini D-SUB

D-SUB 9-pin

 

15-pin

 

Mini D-SUB

8-pin

 

15-pin

 

RGB cable for PC

RS-232C cable

Power cord

(246C521-10)

(246C508-10)

(246C383-20)

Used for projector control by computer.

Remote control parts

 

Others

 

 

• Lens cap (attached to the projector)

• User Manual/Quick Start up (English only) (871D488-10)

CD-ROM (with User Manual) (919C154-10)

• Safety Manual/Quick Start up (871D489-10)

Remote control

R03 (Size-AAA)

(290P133-30)

battery (two)

Important:

• The attached power cord is to be used exclusively for this product. Never use it for other products.

Inserting the batteries into the remote control

1

1.

Remove the back lid of the remote control.

2.

Check the polarity (+), (-) of the batteries, and set them

 

3

correctly, inserting their (-) side first.

 

 

• If the battery is inserted from the (+) side first, inserting

 

 

the (-) side is difficult because the coil spring end hits

 

 

on the battery side. If the battery is forced in this way,

 

2

the outer label of the battery may get ripped and it may

 

cause a short-circuit and heating.

 

 

 

3.

Attach the back lid.

 

Important:

 

Use two size-AAA batteries (R03).

 

Replace the two batteries with new ones when the remote

 

 

control is slow to respond.

Caution:

Use of a battery of wrong type may cause explosion.

Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

Dispose of used batteries according to your local regulations.

Batteries may explode if misused. Do not recharge, disassemble, or throw them in fire.

Be sure to handle the batteries according to the instructions.

Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

Keep batteries out of reach of children and pets.

Remove the batteries, if the remote control is not used for a long time.

Do not combine a new battery with an old one.

If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

EN-6

Page 6
Image 6
Mitsubishi HC1100 Preparing your projector, Checking accessories, Inserting the batteries into the remote control