Installing the Monitor | Mitsubishi Electronics DV180 specs

Installing the Monitor 3

The DV180 monitor is equipped with an auto-sensing power supply that will operate within the voltage range of 100 to 240 Volts AC, at 50~60 Hz.

1.Make sure that the system power is turned off.

2.Plug the signal cable into the

VGA signal connector at the rear of the PC.

3.Plug the end of the power cord to the monitor.

4. Connect the other end of power cord into the wall socket or other power source.

5.Turn the monitor on and then turn the computer on.

6

Image 8

Mitsubishi Electronics DV180 user manual Installing the Monitor

Contents

User’s Manual Page Table of Contents Dealer Information Copyright DisclaimerMonitor Information Safety Instructions and Maintenance Safety Instructions Unpacking the Monitor FeaturesIntroduction Lower Power Consumption Power SavingLight Weight High Quality Ratiometric Expansion Installing the Monitor Connecting the Microphone Connecting the Speaker Connecting Headphones Connecting USB Devices Control Panel Setting up and Using the DV180Using Your Monitor for the First Time Automatic Image Adjustment Microsoft Windows Brightness Hot Key Using the On Screen DisplayContrast Hot Key On Screen Display ContrastBrightness Return Geometry Menu Colour Adjustment Miscellaneous Return Manual Display Setup To adjust the image Supported Graphics Signals and Timings Dot Clock Remark Actual Frequency Display KHz MHz ResolutionPage Troubleshooting and Useful Hints TroubleshootingPage Need More Help? Specifications New Zealand Contacting Mitsubishi ElectricAustralia