Mitsubishi Electronics EX320U-ST Utilizing the password function, PJLink supported commands

•For the specifications of PJLink™, access to the Web site of Japan Business Machine and Information System Industries Association (JBMIA). (http://pjlink.jbmia.or.jp/english)

•This projector is fully compliant to the specifications of JBMIA PJLink™ Class 1. It supports all the commands defined by PJLink™ Class 1, and the compliance has been verified with the PJLink™ standard specifications Version 1.0.

Utilizing the password function

To prevent unauthorized connection to the projector via PJLink™ application, the projector includes an option for setting up password security. To set the password:

1.Open the OSD menu and go to the SYSTEM SETUP: Advanced > LAN Control Settings menu. Press MODE/ENTER. The LAN Control Settings page is displayed.

2.Highlight PJLink Certification and select On by pressing / . The default password is "admin".

3.Press to highlight Change PJLink Password and press MODE/ENTER.

4.Enter the current password. Press , to select the digit and press , to select from 0-9, A-Z, a-z or symbols. Press MODE/ENTER to confirm.

5.Enter the new password and Press MODE/ENTER to confirm.

If you forget the password, please use the password "projectorcontroller".

PJLink™ supported commands

The table below shows commands to control the projector using the PJLink™ protocol.

Commend	Description	Remark (Parameter)
POWR	Power control	0 = Standby
		1 = Power on
		0 = Standby
POWR?	Inquiry about the power state	1 = Power on
		2 = Cooling down
		3 = Warming up
INPT	Input switching	11 = COMPUTER1
		12	= COMPUTER2
INPT?	Inquiry about input switching	21	= VIDEO
		22	= S-VIDEO
		31	= HDMI
AVMT	Mute control	10	= BLANK disable
		11 = BLANK enable
		20	= Audio mute disable
AVMT?	Inquiry about the mute state	21	= Audio mute enable
		30	= BLANK and audio mute disable
		31	= BLANK and audio mute enable
		1st byte: Fan error, 0 or 2
		2nd byte: Lamp error, 0 or 2
		3rd byte: Temperature error, 0 or 2
ERST?	Inquiry about the error state	4th byte: Always 0
		5th byte: Always 0
		6th byte: Always 0
		* 0 or 2 mean as follows:
		0 = No error detected, 2 = Error
		1st value (1 to 4 digits): Cumulative lamp operating time
LAMP?	Inquiry about the lamp state	(This item shows a lamp operating time (hour) calculated
		based on that Lamp Mode is Low.)
		2nd value: 0 = Lamp off, 1 = Lamp on
INST?	Inquiry about the available inputs	The following value is returned.
		"11 12 21 22 31"
NAME?	Inquiry about the projector name	The command responds with the projector name specified in
		the Tools page.
INF1?	Inquiry about the manufacturer	"MITSUBISHI" is returned.
	name

EN-38