Mitsubishi Electronics FC810 manual Usb Dmi

￿!%￿	￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿
￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿ ￿

The BIOS is contained in a flash ROM device – Firmware Hub (FWH) soldered directly to the motherboard and includes the code listed below. The motherboard will automatically perform a BIOS recovery operation if it detects a valid recovery disk during the boot sequence. The BIOS ROM is accessed as a single linear region in the memory space from 4GB-128kB (0FFFE0000 - 0FFFFFFFFh) and copied at the top of ISA memory (0E0000 - 0FFFFFh).

USB

DMI

Setup-in-ROM

￿Intel microcode update support and code Power and system management code

￿￿￿￿￿

The FC810 microATX motherboard contains an integrated graphics controller. However an alternative adapter can be used and fitted to one of the expansion slots. This may be a PCI product.

￿￿￿

The audio system is based around an AC’97 compliant controller. When not fitted, the standard ￿￿&'(￿%￿￿PC beep function remains.

AC-link digital interface with ICH

16-bit stereo full-duplex codec with fixed 48K sampling rate

3 analog line-level stereo inputs for connection from LINE IN, CD, AUX

2 analog line-level mono inputs for connection from PHONE, PC BEEP

Mono MIC input switchable form two external sources

Stereo line level output

Mono output for speakerphone

￿Programmable power management Tone, loudness, 3D stereo enhancements

One power amplifier is used - a National Semiconductor LM4881 ’Boomer’ to drive the LINE- out jack socket and the optional internal speaker. The microphone input provides power to enable condenser microphones to be used.

MITSUBISHI ELECTRIC MOTHERBOARD DIVISION PAGE 19 OF 45