OPERATING PROCEDURE | PHOTOS | |
6. Operation panel |
| |
How to remove | Figure 3 | |
(1)Slide the operation panel in the direction of the arrows, unit it |
| |
stops. (See figure 3.) |
| |
(2)Pull out the operation panel as shown in a figure 4. | Operation | |
(See figure 4.) | ||
panel | ||
|
Note :
1 Please pull it out carefully because it is still wired to the body.
(3)Take out the panel by detaching the connector of lead wires from Figure 4 the body.
(See figure 5.)
Note :
1 If the horizontal slide is hard to remove with hands, put plate |
| |
on the right edge of the panel (please put protective object such |
| |
as tapes on the area of contact on the door panel and the opera- |
| |
tion panel), and gently tap it in the sliding direction. | Figure 5 | |
(See figure 3.) | ||
|
Connector
7. Rotational heater board | Photo 14 |
(1)Remove four fixing screws to remove the rotational heater |
|
board. (See photo 14) | Screws |
(2)Remove a screw on the wiring cover and disconnect the | |
connector in the cover. (See photo 14) | Wiring cover |
|
Caution on assembly |
|
|
|
When raising the rotational heater board, replace the rotational | Rotational |
|
|
heater board as it was. if the refrigerator door is closed with the |
|
| |
board raised, the rotational heater board may hit against the | heater board |
|
|
left door of refrigerator and be damaged. |
|
|
|
Though heater preventing dewdrop may make rotational heater |
|
|
|
board hot, it does not affect food inside. |
|
|
|
Refer to right figure when installing the rotational heater board. | Screws |
|
|
(See figure 6) |
|
| |
|
|
| |
●Loosen the fixing screw and adjust a vertical (upper and lower) |
|
|
|
motion. | Figure 6 |
|
|
●After assembling, make sure that the rotational heater board fits |
| Guide |
|
the guide properly and works properly. | Rotational heater |
| |
| board | 3i2mm | |
| Left door of |
| (715) |
| refrigerator |
| |
|
|
| |
| compartment | (4)mm |
|
38
