INSTALLATION
Placing Heater on Mounting Bracket
1.Install wall spacers.
2.Attach two (2) rubber bumpers to back of heater as shown in Figure 10.
3.Locate two (2) horizontal slots on back panel of heater.
4.Place heater onto mounting bracket. Slide horizontal slots onto
Horizontal Slots
Tabs
Mounting
Bracket (already attached to wall)
B. MOUNTING HEATER ON OPTIONAL HEARTH BASE
Tools needed: |
|
• #2 Phillips screwdriver | • slotted screwdriver |
• electric drill (if securing base to floor)
The optional hearth base kit includes the following:
• Hearth Base | • 4 Wood Screws | • 4 | Sheet Metal Screws |
• Hearth Insert | • 4 Anchors | • 2 | Brass Screws |
Figure 10 - Mounting Heater Onto
Mounting Bracket
• Brass Base Trim
Rubber
Bumpers
Note: To secure hearth base to floor, follow instructions under “Securing Hearth Base to Floor,” page 16. If not securing hearth base to floor, proceed to “Mounting Heater to Optional Hearth Base,” page 16.
Continued
49D0090 | 15 |