PRODUCT IDENTIFICATION AND ASSEMBLY
SAFETY DEVICE
This heater has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
THERMOSTAT HEAT CONTROL
This heater has a thermostat sensing bulb and a control valve. This results in the greatest heater comfort. This can also result in lower gas bills.
NOTE: Do not remove Lighting and Warning Plates from heater.
UNPACKING
1. | Remove heater from carton. |
2. | Remove all protective packaging applied to heater |
| for shipment. |
3. | Make sure your heater includes the following: |
Door
Optional Blower
On/Off Switch
Hood
Screen
Control
Knob
Piezo
Ignitor
trim |
hood |
mounting bracket |
hardware package which includes: |
two (2) 90° angled brackets and shims |
four (4) trim screws |
three (3) hood screws |
two (2) wall mounting screws |
two (2) wall spacers |
4. Check heater for any shipping damage. If heater is |
damaged, promptly inform dealer where you bought |
heater. |
Figure 1 - Vent-Free Gas Log Space Heater
Screws
Deflector
ASSEMBLY
INSTALLING HOOD
1.Remove hood from protective package.
2.Locate three (3) black sheet metal screws inside home- owner’s manual pack.
3.Place hood on deflector and line up holes (see Figure 2).
4.Secure hood to deflector with three (3) black sheet metal screws.
NOTE: Side of hood should be on the outside flange of deflector.
Hood
Figure 2 - Installing Hood
6 | 49D0090 |