Monessen Hearth DEB20, DEB30 manual Log Placement, INSTALLING LOGS ON GRATE See Figures 25 and

Models: DEB20 DEB30

1 40
Download 40 pages 19.41 Kb
Page 26
Image 26
LOG PLACEMENT
Left Front Pin

LOG PLACEMENT

Before you begin — This unit is supplied with four or five ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.

WARNING

The positioning of the logs are critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater. Only use the logs supplied with the unit.

Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal injury.

INSTALLING LOGS ON GRATE (See Figures 25 and 26 )

NOTE: Model DEB18 has 4 logs and models DEB24 and DEB30 have 5 logs.

1.Install back log (#1) on two pins located near the back of base. Check log position and stability.

2.Install right center log (#2) on pins located near right front of base and center of base.

NOTE: The #2 log is a heat shield for the control valve. It is critical that this log is sitting in its pin placement and completely down with the front noise of the embers placed below the front burner. If the #2 log is not placed properly it could cause damage to the control valve and wiring.

3.Install left center log (#3) on pin located near left front of base and on top of right center log (#2).

4.Install middle front log (#4) in front of center log. Make sure bottom of log is resting on the center of grate. Do not let log #4 contact the front burner.

5.DEB 24 and DEB 30 only: Rest right end of left front log (#5) on log #3 and the top of left front log on log #1.

6.Place back end of top center log (#5) on recessed area of back log (#1). Cross log #6

over log #2 and rest right extension on grate. Log #6 should fit on pin on center log #3.

 

Log #6

 

Log #6

 

 

 

 

 

Log

 

 

Log #4

 

 

 

 

 

#4

 

Log #5

 

 

 

 

 

 

 

Log

(24 & 30

Log

 

only)

Log #3

#1

 

#1

 

 

 

 

Log

 

Log

#3

Log

#2

 

#2

 

Back

 

Back

Pins

 

 

Pins

 

 

 

Left Front Pin

Right Front and

 

Right Front and

Center Pins

 

Center Pins

Figure 25 - Installing Logs

 

Figure 26 - Installing Logs

 

to Grate

to Grate (Model DEB20)

 

(Models DEB24 and DEB30)

26

44D0060

Page 26
Image 26
Monessen Hearth DEB20, DEB30 manual Log Placement, INSTALLING LOGS ON GRATE See Figures 25 and