Monessen Hearth DEB30, DEB20 Electrical Wiring Milli-Volt, Connecting Remote Receiver, Settin

ELECTRICAL WIRING (MILLI-VOLT)

CONNECTING REMOTE RECEIVER

1.Connect the connectors to the two .25" male con- nectors located on the right side when facing the unit (Figure 19). Do not let the wire touch the grate or burners.

NOTE: Heat reduces battery life. You can protect the receiver and extend battery life by mounting the receiver in a wall or other location outside the fireplace.

Remote

Wire

Connectors

Remote

Receiver

Figure 19 - Installing Remote Receiver

INSTALLING T-STAT SENSOR (OPTION SOLD SEPARATELY)

1.Remove metal bracket and label from box.

2.Peel away the paper backing on the label. Line up holes in label with holes on the bracket. Right side of label should flush with right side of bracket. See Figure 20. Press label firmly and smoothly to bracket.

3.Using Phillips screwdriver, install t-stat sensor to bracket with two screws provided. See Figure 21. Make sure the thermo bulb wire is at the bottom of t-stat sensor.

4. Plug in wiring harnesses to back of t-stat sensor. See Figure 21.

Bracket

T-Stat

Sensor

Wiring

Harnesses

THER
SETTIN
			MOSTAT
			G
Line Up			HIGH
Holes
2
6D3
3
	1
		7	LOW

THER
SE MOS
TT	T
	INGAT
	HI
	GH
26
D33
17	LOW

Flush edge of label to

right side of bracket Screws

Thermo Bulb

Figure 20 - Applying Label to Bracket	Figure 21 - Installing T-Stat Sensors
	and Wiring Harnesses

44D0060 23