Manuals / Monessen Hearth / Household Appliance / Indoor Fireplace

Monessen Hearth DFS32NVC, DFS36NVC, DFS42NVC, DFS32PVC, DFS42PVC, DFS36PVC manual Contents

Models: DFS36PVC DFS36NVC DFS32PVC DFS42PVC DFS42NVC DFS32NVC

1 44

Download 44 pages 55.71 Kb

Page 2

CONTENTS

Important Safety Information	3	Electrical Wiring (Milli-Volt)	19
Product Features	5	Connecting Optional Wall Switch	19
Operation	5	Connecting Remote Receiver	20
Speciﬁcations	7	Checking System Operation	20
Ignition Controls	7	Log Placement	21
Pilot	7	Flame Appearance	25
Thermal Generator	7	Checking the Burner Flame	26
Getting Started	8	Operating Instructions	27
General Installation Information	9	For Your Safety Read Before Lighting	27
Firebox Dimensions	9	Milli-Volt Control Lighting Instructions	28
Codes	10	Match Lighting Instructions	29
Adequate Combustion and Ventilation Air	10	Cleaning and Servicing	29
Removing Screen	12	Blower and Other Optional Equipment	...............30
Installing Canopy	12	Illustrated Parts Breakdown	31
Location of Fireplace	13	Logs	31
Clearances and Height Requirements	14	Heater	32
Fireplace Framing	15	Cabinet	34
Connecting the Gas	17	Troubleshooting	36
Checking Gas Pressure	18	Trim Installation	38
Milli-Volt Control	18	Using Optional Outside Air Kit	40
		Warranty	Back Cover

2

71D0532

Image 2

Monessen Hearth DFS32NVC, DFS36NVC, DFS42NVC, DFS32PVC, DFS42PVC, DFS36PVC manual Contents

Contents

What to do if YOU Smell GAS Read and Save These Instructions Contents Owner Important Safety InformationInstaller From Product Features Operation Natural GAS PROPANE/LPG Specifications Make Sure YOU have Received ALL Parts What YOU will Need for InstallationGetting Started General Installation Information Firebox Dimensions with Screen and Log Sets Codes Adequate Combustion and Ventilation AIR BTU/Hr = 15 1/ 2 x 12 x 1000 = 29760 BTU/Hr Installing Canopy Removing Screen Do not Install this Model in a Bedroom or Bathroom Location of Fireplace Clearances and Height Requirements 21/2 16 1921 Fireplace Framing Framing surface ﬁreplace must be installed giving Connecting the GAS Flexible Tube Manual Shutoff Gas Supply Inlet Valve Checking GAS Pressure MILLI-VOLT Control Figure Operate Electrical WiringConnecting Optional Wall Switch Complete MILLI-VOLT System Check Connecting Remote ReceiverChecking System Operation LOG Placement Installing Charred Timber Logs on Burner Installing Left Base Log #3 Installing Left Top Log #5 Installing Right Top Log #6 Placing Rock Wool MILLI-VOLT Control Flame AppearanceChecking the Pilot Flame Checking the Burner Flame Correct Appearance of Rear Flames of Charred Timber Operating Instructions For Your Safety Read Before Lighting MILLI-VOLT Control Lighting Instructions Operating Instructions Operating Instructions and Cleaning and Servicing Cleaning and Servicing Forced AIR KIT Blower and Other Optional EquipmentOptional Equipment Optional Trim Illustrated Parts Breakdown Charred Timber Logs Illustrated Parts Breakdown Accessories Sold Separately Replacement Parts ListBurner Assembly Illustrated Parts Breakdown BRC36 BRC42 Troubleshooting Observed Problem Possible Cause Remedy ODS/pilot lights, but flame Trim Installation Trim Installation For USE of Optional AK-4 Outside AIR KIT Combustion AIR Model AK-4 Combustion AIR Assembly Insulation Ring to Left Side of Fireplace Installing Model 403 Duct Connector 71D0532 Five Year Warranty Basic Warranty