TRIM INSTALLATION
1.Remove top and bottom louver assemblies by disengaging hooks. Pull assemblies up and away from unit. See Figure 33.
2.Remove canopy by removing screws and pulling canopy away from unit. See Figure 34.
3.Set bottom trim kit piece in place on bottom of face. Bottom piece will be held in place by the side pieces. See Figure 34.
Figure 33 | Figure 34 |
4. Loosely install four supplied screws into left and right sides of unit face.
Leave approximately 1/8th in. of screw shaft protruding from unit in each location. See Figure 35.
5. Set left and right side piece of trim kit in place on unit. Lean the top of each piece away from the unit and towards you in order to install top trim kit piece. Top piece should fit with sides as shown.
See Figures 36, 37 & 38
Figure 35
38 | 71D0532 |
