Floor Clearance | Monessen Hearth dst30 manual

FLOOR CLEARANCE

The gas log heater must be installed at least 5" above any combustible ﬂooring material, such as carpeting or tile, which is closer than 14" to the base of the ﬁreplace. The minimum distance must be maintained from the top surface of carpeting, tile, etc. Refer to Figure 9.

OR,

The gas log heater may be installed nearer to the ﬂoor if a minimum of 14" of noncombustible material such as slate or marble is installed between the base of the ﬁreplace and the combustible ﬂooring. Refer to Figure 10.

Heater in

Fireplace or

Firebox

Combustible

Material

5" Minimum

Figure 9 - Minimum Clearance above Combustible Flooring

This Distance May Now Be Less than 5"

Heater in

Fireplace or

Firebox

Combustible

Material

14" Minimum

Figure 10 - Minimum Clearance above Combustible Flooring with

Noncombustible Material Installed at Base of Fireplace

43D0122

15

Image 15

Monessen Hearth dst30 operating instructions Floor Clearance, Minimum Clearance above Combustible Flooring

Contents

Model DST30 Read and Save These InstructionsWhat to do if YOU Smell GAS Contents Important Safety Information InstallerOwner For Massachusetts Residents only What YOU will Need for Installation Getting StartedMake Sure YOU have Received ALL Parts Product Features and Specifications Natural GASPROPANE/LPG General Installation Information CodesAdequate Combustion and Ventilation AIR BTU/Hr = 15 1/ 2 + 12 x 12 x 1000 = 52800 BTU/Hr Fireplace and Hearth Dimensions Height of Restriction Minimum Depth of Fireplace/Firebox Placement in a Fireplace with a Restrictive Barrier Sidewall and Ceiling Clearances Clearances and Height Requirements Clearances and Height Requirements Measuring Heat Resistant Material for Mantel Maximum of 10 at a minimum of 28 above the ﬁrebox Clearances and Height Requirments Minimum Clearance above Combustible Flooring Floor Clearance Damper Stop Installation Installing Vented ApplicationsBefore Fully Installing the Unit Before Installing the Appliance Installing Vented Applications Assembly ProcedurePlacing and Securing Appliance Gas Connection Connecting the GAS MILLI-VOLT Control Figure Checking GAS Pressure Electrical Wiring MILLI-VOLT Connecting Optional Wall Switch or ThermostatOperate Connecting Remote Receiver Checking System OperationComplete Millivolt System Check Placing the Decorative Rock LOG Placement Flame Appearance Checking the Pilot FlameMILLI-VOLT Control Operating Instructions Checking the Burner Flame For Your Safety Read Before Lighting Operating InstructionsWhat to do if YOU Smell GAS To Turn OFF GAS to Heater MILLI-VOLT Control Lighting Instructions Operating Instructions and Cleaning and Servicing Cleaning and ServicingMatch Lighting Instructions Observed Problem Possible Cause Remedy Troubleshooting Burner does not light after ODS Illustrated Parts Breakdown Replacement Parts are Available Through Your Retailer Replacement Parts List Lifetime Warranty Five Year WarrantyBasic Warranty