GETTING STARTED

MAKE SURE YOU HAVE RECEIVED ALL PARTS:

Check your packing list to verify that all listed parts have been received. You should have the following:

• Unvented gas log grate/burner assembly

• Plastic bag containing crushed volcanic rock

Installation/operating instructions

Four (4) anchoring screws

Ceramic Fiber logs

Four (4) self-tapping screws

The milli-volt controlled version of this heater is the only style designed to be operated with optional devices for ON/OFF functions. The following options may be used with the millivolt controlled heater. These options are not packaged with the log set.

Hand held Remote with receiver

Wall thermostat with 15' wire

Wall switch with 15' wire

Hand held Thermostat Remote with receiver

CAUTION

Handle the gas log burner assembly by the grate only. Do not pick the unit up by the burners.

Gloves are recommended when handling ceramic fiber logs to prevent skin irritation from loose fibers. Logs are fragile — handle with care.

Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you

have all parts in good condition.

WHAT YOU WILL NEED FOR INSTALLATION:

You must have the following items available before proceeding with installation:

• External regulator (for propane/LPG and 1/2 lb. or greater, natural gas systems)

Piping which complies with local codes

Sediment trap

Screwdriver

Tee joint.

• Pipe sealant approved for use with propane/LPG (Resistant to sulfur compounds)

• Drill with 5/32 bit

• Pipe wrench or appropriate size crescent wrench set

• Manual shutoff valve

43D0122

5

Page 5
Image 5
Monessen Hearth dst30 Getting Started, Make Sure YOU have Received ALL Parts, What YOU will Need for Installation