GETTING STARTED
The Axiom CMD11E1 single board computer is a fully assembled, fully functional development system for the Motorola 68HC11E1 microcontroller, complete with wall plug power supply and serial cable. Support software for this development board is provided for Windows 95 and NT operating systems.
Follow the steps in this section to get started quickly and verify everything is working correctly.
Installing the Software
1.Insert the Axiom 68HC11 support CD in your PC. If the setup program does not start, run the file called "SETUP.EXE" on the CD.
2.Follow the instructions on screen to install the AxIDE software onto your hard drive.
3.After installation completes,
4.Select the PC serial port you're using to connect to the board. Click [OK].
5.Select your development board "CMD11E1" from the
Board Startup
Follow these steps to connect and power on the board. This assumes you're using the provided AxIDE terminal (installed in the previous section) or a similar communications terminal program on your PC, and that all jumpers are in their default (from the manufacturer) positions. If you're using a different terminal program than the one provided, set it's parameters to 9600 baud, N,8,1.
1.Connect one end of the supplied
2.Apply power to the board by plugging in the wall plug power adapter that came with the system.
3.If everything is working properly, you should see a Buffalo Monitor prompt similar to that below in the Terminal window. Press the ENTER key and you should see a prompt which is the > character.
BUFFALO 3.4AX – Axiom Version of the Motorola Monitor / Debugger >_
4. Your board is now ready to use!
3
