Motorola CME-12D60 manual Getting Started, Installing the Software, Board Startup

GETTING STARTED

The Axiom CME-12D60 single board computer is a fully assembled, fully functional development system for the Motorola 68HC912D60 microcontroller, complete with wall plug power supply and serial cable. Support software for this development board is provided for Windows 95/98 and NT operating systems.

Follow the steps in this section to get started quickly and verify everything is working correctly.

Installing the Software

1.Insert the Axiom 68HC12 support CD in your PC. If the setup program does not start, run the file called "SETUP.EXE" on the disk.

2.Follow the instructions on screen to install the support software onto your PC. You should at minimum install the AxIDE for Windows software.

3.The programming utility “AxIDE” requires you to specify your board. You should select "CME12D60" for this board.

Board Startup

Follow these steps to connect and power on the board. This assumes you're using the provided AxIDE utility (installed in the previous section) or a similar communications terminal program on your PC. If you're using a different terminal program than the one provided, set it's parameters to 9600 baud, N,8,1.

1.	Make certain the CONFIG SWITCH is set as follows:
		1	2	3	4	5	6	7	8
		ON	ON	ON	ON	OFF	ON	OFF	OFF
2.	Connect one end of the supplied 9-pin serial cable to a free COM port on your PC.
	Connect the other end of the cable to the COM1 port on the CME-12D60 board.
3.	Apply power to the board by plugging in the power adapter that came with the system.
4.	If everything is working properly, you should see a message to “PRESS KEY TO START
	MONITOR…” in your terminal window. Press the ENTER key and you should see:
	Axiom MON12 - HC12 Monitor / Debugger
	> _
5.	Your board is now ready to use! If you do not see this message prompt, or if the text is
	garbage, see the TROUBLESHOOTING section at the end of this manual.

3