Motorola GP68 Routing Code Destination, Subscriber To Landline Call, Conventional Mode

1 • Operation

Table 1-1 • Call Routing Codes

Routing Code	Destination
1	Subscriber to Landline 1
2	Subscriber to Landline 2
3	Subscriber to Subscriber
4	Fleet-Dispatch/Group Call
5	Conventional Mode
9	Mobile Operator
0	Emergency

1.3.1Subscriber To Landline Call

Routing codes 1 and 2 give the subscriber access to tele- phone line one or two respectively. A subscriber may be restricted from line 2, or there may not be two telephone lines connected to the ST-852M. In this case, routing code 2 is not valid.

1.3.2Subscriber To Subscriber Call

Routing code 3 allows the subscriber to place a call to an- other subscriber or group of subscribers. The call is routed through the ST-852M and does not use the telephone sys- tem.

1.3.3Fleet Dispatch (Subscriber) To Group Call

Routing code 4 allows the subscriber to place a call to the subscriber’s own group. This functions as though the sub- scriber had used routing code 3 with the subscriber ID num- ber of the subscriber’s own group. When automatic PTT is enabled, operation of the PTT initiates a group call to the subscribers group using routing code 4.

1.3.4Conventional Mode

Routing code 5 selects conventional mode. In this mode, radio channel switch positions not used by SmarTrunk II trunking channels may be programmed and used for con- ventional two-way radio operations. This feature is enabled or disabled during initial setup of the radio. Availability of this mode is determined by the radio dealer supplying the radio, or the System Operator/Manager.

11