Motorola GP68 operation manual Primary Code, Secondary Code, Priority Subscriber Enable

Model ST-865M3 SmarTrunk II ™ Logic Board

4.2.2Primary Code

The Primary Code consists of a four digit number that is contained in the SmarTrunk II digital transmission. Any four digit number from 0000 to 9999 may be used. See Section 2 (Operating Modes) before assigning the Pri- mary Code.

To program the Primary Code: Enter the program code 12 followed by the # key, then the Primary Code fol- lowed by the # key.

Example: To program a unit’s Primary Code to 1234

press: 1 2 # 1 2 3 4 #.

4.2.3Secondary Code

The Secondary Code consists of a four digit number contained in the SmarTrunk II digital transmission. Any four digit number from 0000 to 9999 may be used.

See Section 2 (Operating Modes) before assigning the Secondary Code.

To program a Secondary Code: Enter the program code 13 followed by the # key, then the Secondary Code followed by the # key.

Example: To program a unit’s Secondary Code to 1200 press: 1 3 # 1 2 0 0 #.

4.2.4Priority Subscriber Enable

Enabling this program code makes a subscriber unit a Priority Subscriber. A Priority Subscriber can pre-empt calls currently in progress on the trunking system.

Note: Care must be exercised when using this fea- ture. A priority subscriber can terminate im- portant calls of other subscribers. If too many priority subscribers are enabled, the priority subscribers themselves will be competing for trunking channels. Additional trunking chan- nels should be installed if the system is heavily loaded.

34