Allied Telesis AT-8700XL, RAPIER I, X900-48FE Enable switch debug, Enable switch filter vlansecure

Software Version 2.8.1 35

Example To disable the default vlan on port 1, use the command:

dis swi po=1 vlan=1

enable switch debug

Syntax ENAble SWItch DEBug={ARLDEVDMAPHYALL} [OUTPUT=CONSOLE] [TIMEOUT={1..4000000000NONE}]

Description The m6 parameter is now replaced by the dev parameter in this command.

Debug Option	Description
DEV	Debugging is disabled for operations related to the switch chip.

enable switch filter vlansecure

Syntax ENAble SWItch FILter VLANSecure

Description This new command returns Layer 2 switch filtering to its default behaviour by enabling vlansecure mode. The vlansecure mode is enabled by default.

When vlansecure mode is enabled and a filter exists for a given host and port, moving the host to a different port blocks the host completely. When vlansecure mode is disabled and a filter exists for a given host and port, moving the host to a different port in the same VLAN only stops the host from accessing that VLAN, not other VLANs.

Example To turn on the default filtering behaviour, use the command:

ena swi fil vlan

enable switch port vlan

Syntax ENAble SWItch POrt={port-listALL}

VLAN[={vlan-name1..4094ALL}]

where:

■port-listis a port number, range (specified as n-m), or comma-separated list of numbers and/or ranges. Port numbers start at 1 and end at m, where m is the highest numbered Ethernet switch port, including uplink ports.

■vlan-nameis a unique name from 1 to 32 characters. Valid characters are uppercase and lowercase letters, digits, the underscore, and hyphen.

Description This new command enables one or more ports for VLANs to which they belong. A port is automatically enabled for a VLAN when it is added to that VLAN, however, it can be disabled using the disable switch port vlan command, or automatically disabled by thrash limiting or QoS protection.

The port parameter specifies the port or ports to enable. If a trunked port is specified, all ports in the trunk are enabled.

Software Version 2.8.1 C613-10477-00 REV B