Allied Telesis X900-48FE, RAPIER I, AT-8900, AT-8700XL, AT-9900, AT-8600, AT-9800, AT-8800 Show switch

Software Version 2.8.1 41

Table 4: New parameters in output of the show lacp command

Parameter		Description
Address learn thrash	The thrashaction value that is applied to any trunks created by
action	LACP. This specifies the action the router or switch takes when the
	address learn thrash limit is exceeded on the trunk.
	Disable Learning	Learning is disabled on all ports in the trunk
	Disable Port	All ports in the trunk are disabled but the links
		will remain up
	Link Down	All ports in the trunk are disabled and the links
		will go down
	Disable Vlan	All ports in the trunk are disabled for the
		VLAN that thrashing occurring on.
Address learn thrash	The thrashtimeout value to apply to any trunks created by LACP. It
timeout	specifies the time, in seconds, for which a trunk remains disabled
	after being disabled by thrashing protection.

If ‘None’ is shown, the trunk remains disabled until manually re-enabled.

show switch

Syntax SHow SWItch

Description This command now shows information about the hardware route update queue (Figure 5, Figure 6, Table 5).

Figure 5: New parameters in output of the show switch command when hardware learning delay is disabled

Switch Configuration

-----------------------------------------------------------

Switch Address	00-00-cd-12-78-03
Learning	ON
Ageing Timer	ON
IP route:
Learn delay	OFF
queue limit	1000000
queue maximum	1500000
queue default	1000000
Updating hardware(status)	0 (Pending)
.
.
.

Software Version 2.8.1 C613-10477-00 REV B