Allied Telesis X900-48FE, RAPIER I, AT-8900, AT-8700XL manual Set ospf, BGPImport=ONOFFTrueFalseYESNO

Software Version 2.8.1 97

debugging is set with the detail parameter, but the output always contains the direction of the packet, the type of packet, the version of OSPF, the packet’s source and destination, the router ID, area, length, checksum and authentication type. If redistribute is specified, route redistribution debugging is enabled. If spf is specified, debugging for the Shortest Path First routing calculations is enabled. If state is specified, both interface and neighbour state debugging are enabled.

set ospf

Syntax SET OSPF [ASExternal={ONOFFNSSA}]

[BGPFilter={0..999NONE}]

[BGPImport={ONOFFTrueFalseYESNO}]

[BGPLimit=1..4000] [AUTOCOST={ONOFF}] [DEFRoute={ONOFFTrueFalseYESNO}] [DYNInterface={STUBASExternalNONENOOFFFalse}] [INRoutemap={routemapNONE}] [METRIC=0..16777215] [PASSiveinterfacedefault={ONOFFTrueFalseYESNO}]

[REFBANDWIDTH=10..10000] [RIP={OFFEXportIMportBOTH}]

[ROuterid=ipadd] [PTPStub={ONOFFYESNOTrueFalse}]

[STATicexport=(YESNO)] [TYPE={12}]

where:

■ipadd is an IP address in dotted decimal notation

■routemap is the name of an IP route map

Description No parameters or options have changed. However the behaviour of some parameters has changed:

■For compatibility, the asexternal, bgpimport, rip, and staticexport parameters are synchronised with the equivalent redistribution definition. Changing the setting of these parameters will add or delete the corresponding route redistribution definition. Similarly, adding or deleting a route redistribution definition changes the setting of the corresponding bgpimport, rip, or staticexport parameter.

■The asexternal parameter no longer imports and redistributes non-OSPF interface routes.

Software Version 2.8.1 C613-10477-00 REV B