50

MSTP Enhancement

Release Note

MSTP Enhancement

Two new commands have been added to simplify MSTP operation.

Command Changes

The following table summarises the new commands:

Command

Change

 

 

disable mstp port

New command

 

 

enable mstp port

New command

 

 

Command Reference Updates

This section describes each new command.

disable mstp port

Syntax DISable MSTP POrt={port-listALL}

where:

port-listis a port number, range (specified as n-m), or comma-separated list of port numbers and/or ranges. Port numbers start at 1 and end at m, where m is the highest numbered Ethernet switch port, including uplink ports.

Description This new command disables the Multiple Spanning Tree algorithm on the specified ports, or all ports, for both the CIST and all currently configured MSTIs. This command offers a shorter alternative to using the disable mstp cist port command, followed by the disable mstp msti port command.

Example To disable the CIST and all MSTIs on ports 10-15, use the command:

dis mstp po=10-15

enable mstp port

Syntax ENAble MSTP POrt={port-listALL}

where:

port-listis a port number, range (specified as n-m), or comma-separated list of port numbers and/or ranges. Port numbers start at 1 and end at m, where m is the highest numbered Ethernet switch port, including uplink ports.

Description This new command enables operation of the Multiple Spanning Tree algorithm on the specified ports, or all ports, for the both the CIST and all currently configured MSTIs. This command offers a shorter alternative to using the enable mstp cist port, command, followed by the enable mstp msti port commands.

Example To enable the CIST and all MSTIs on ports 10-15, use the command:

ena mstp po=10-15

Software Version 2.8.1 C613-10477-00 REV B

Page 50
Image 50
Allied Telesis AT-8900, RAPIER I, X900-48FE, AT-8700XL, AT-9900, AT-8600 Mstp Enhancement, Disable mstp port, Enable mstp port