Allied Telesis AT-9800 manual Example script for a 4 node ring network, # For Transit Nodes 1, 2

8 Software Reference

Figure 1-4shows a sample of the commands required to configure this network.

Figure 1-4: Example script for a 4 node ring network

#EPSR configuration for a simple 4 node ring network

#For the Master Node

#Set the Acceptable Frame Types parameter to admit only VLAN tagged frames on

#ports 1 and 2.

set switch port=1 acc=vlan set switch port=2 acc=vlan

# Create VLANs

create vlan=control_ring vid=2 create vlan=data_ring vid=100

# VLAN Port Configuration

add vlan=control_ring port=1-2 frame=tagged add vlan=data_ring port=1-2 frame=tagged

#Remove the Default VLAN from ports 1-2 del vlan=default po=1-2

#EPSR Configuration

create epsr=domain_one mode=master controlvlan=control_ring primaryport=1 add epsr=domain_one datavlan=data_ring

enable epsr=domain_one

#For Transit Nodes 1, 2, 3

#Set the Acceptable Frame Types parameter to admit only VLAN tagged frames on

#ports 1 and 2.

set switch port=1 acc=vlan set switch port=2 acc=vlan

# Create VLANs

create vlan=control_ring vid=2 create vlan=data_ring vid=100

# VLAN Port Configuration

add vlan=control_ring port=1-2 frame=tagged add vlan=data_ring port=1-2 frame=tagged

#Remove the Default VLAN from ports 1-2 del vlan=default po=1-2

#EPSR Configuration

create epsr=domain_one mode=transit controlvlan=control_ring add epsr=domain_one datavlan=data_ring

enable epsr=domain_one

Configuring the other (non EPSR) ports is outside the scope of this example.