Allied Telesis AT-9800, RAPIER I, X900-48FE, AT-8900, AT-8700XL, AT-9900 Thrashaction is set to none

46 Switching Enhancements Release Note

Table 9: New parameters in output of the show switch port command (cont.)

Parameter	Meaning
Address learn thrash	The thrashing protection status of the port. If the thrash action is
status	set to vlandisable, the status is shown for each VLAN that the
	port is a member of, with each VLAN listed on a separate line.
	Not Detected	Thrashing has not been detected on the port.
	Thrashing	Thrashing has been detected and the specified
		thrash action has been applied.
	Disabled	Thrashing protection is disabled because the
		thrashaction is set to none.
	Trunked	The port is trunked and therefore thrashing
		protection is controlled by the trunk.

Address learn thrash action

Action taken when the address learn thrash limit is exceeded:

Disable Learning	Address learning on the port is temporarily
	disabled.
Disable Port	The port is disabled, but the link remains up.
Link Down	The port is disabled, and the link is down.
Disable VLAN	The port is disabled for the VLAN on which
	thrashing is occurring.

Address learn thrash	The time, in seconds for which a port remains disabled after being
timeout	disabled by thrashing protection. When a timeout value is
	specified and the port is currently disabled by the thrash limit, the
	time remaining before the port is re-enabled is shown in
	parentheses.
	None	The port remains disabled until manually
		re-enabled.
VLAN Status Trap	Whether an SNMP trap is sent when a port is enabled or disabled
	for the VLAN. Either on or off.

Software Version 2.8.1 C613-10477-00 REV B