Allied Telesis AT-8700XL STORMRate, Is matching STORMTimeout, Enable switch port vlan command

Software Version 2.8.1			131
	Parameter (cont.)	Description (cont.)
	STORMRate	Storm protection is activated when this rate of traffic is exceeded.
		Required when storm protection is enabled.
		If the value of stormwindow is less than one second, the rate is
		averaged over the last second.
		Default: none
		Rate	Bits per second from 1Kbps to 10Gbps, specified in
			Kbps, Mbps or Gbps. If you do not specify a unit, it
			uses Kbps. If you specify Mbps or Gbps, the rate may
			contain a decimal fraction with up to 3 decimal
			places, for example, 1.25 Mbps.
		NONE	Storm protection is inactive.
	STORMAction	Action QoS takes when a storm is detected on a port.
		Default: portdisable
		LINKDown	Operationally disables ports to which the traffic class
			is attached.
		POrtdisable	Administratively disables ports to which the traffic
			class is attached.
		VLANdisable	Administratively disables ports to which the traffic
			class is attached for the VLAN on which the classifier
			is matching.
	STORMTimeout	Length of time the port remains disabled after a storm is detected.
		Default: none
		timeoutlength	Duration in seconds from 1 to 86400.
		NONE	The port remains disabled until you enable it again
			with the enable switch port command, or the
			enable switch port vlan command.

Example The following command enables storm protection as follows:

■creates QoS traffic class 1 with a description of stormprotection

■enables storm protection on the traffic class

■checks traffic every 200 milliseconds

■if the rate exceeds 50kbps, then activates storm protection

■when activated, storm protection operationally disables the port for 60 seconds

cre qos tr=1 desc=stormprotection storms=ena stormw=200 stormr=50kbps storma=linkd stormt=60

Software Version 2.8.1 C613-10477-00 REV B