Allied Telesis AT-8600, RAPIER I, X900-48FE, AT-8900, AT-9900 Show switch port, Meaning, Mode, Port

Software Version 2.8.1		45
	Table 8: Modified parameters in output of the show switch hwfilter command
	Parameter	Meaning
	Mode	Whether the router or switch expects hardware filters to be ordered
		with port-specific filters first (“PSF”), or non port-specific filters first

(“NPSF”). This only displays for models with 48 ports (two switch instances).

show switch port

Syntax SHow SWItch POrt[={port-listALL}]

Description This command displays general information about all ports or a specific one.

Figure 10: Example output from the show switch port command for port-based VLANs

Switch Port Information

------------------------------------------------------------

Port	49
Description	To intranet hub, port 49
Status	ENABLED
Link State	Up
UpTime	02:35:26
Port Media Type	ISO8802-3 CSMACD
Configured speed/duplex	Autonegotiate
Actual speed/duplex	1000 Mbps, full duplex
MDI Configuration (Polarity) .. Manual (MDI)
Loopback	Off
Configured master/slave mode .. Not applicable
Actual master/slave mode	Not applicable
Acceptable Frames Type	Admit All Frames
Disabled egress queues	Q0, Q3-4
BCast & MCast rate limit	400 Kbytes\sec
BCSC rate Limiting	Broadcast and Multicast enabled
Egress rate limit	10240 K/bs
Learn limit	-
Intrusion action	Discard

Current learned, lock state ... 0, locked by thrashing

Address learn thrash status ....Thrashing

Address learn thrash action ... Disable Learning

Address learn thrash timeout .. 1 second

VLAN Status Trap	OFF
.
.
.

Table 9: New parameters in output of the show switch port command

Parameter Meaning

Port Number of the switch port.

Software Version 2.8.1 C613-10477-00 REV B