Allied Telesis AT-8700XL manual Enable lldp cdp interface, Enable lldp cdp ppptemplate, Neighbours

Software Version 2.8.1 195

enabled on a particular device, no other debugging mode can be enabled on any other device simultaneously.

CDP debugging is disabled by default.

Parameter	Description
DEBug	The debugging mode to enable.
	PACket	Enables debugging of the reception of CDP
		advertisements.
	ADJacency	Enables debugging of the creation and deletion of CDP
		neighbours
	EVent	Enables debugging of error conditions, such as bad
		packets.
	PPP	Enables debugging of PPP events.

enable lldp cdp interface

Syntax ENAble LLDP CDP INTerface=interface

where interface is the interface on which to enable CDP, one of:

■ethn

An Eth port, where n is the Eth port instance (for example, eth0)

■portm

A switch port, where m is the port number (for example, port2 for the switch port numbered 2)

■pppm

A PPP interface, where m is the interface number

Description This command enables CDP on the specified interface, which has been previously disabled using the disable lldp cdp interface command. For the specified interface only, the reception of CDP advertisements begins, and neighbour entries are added as they are discovered.

CDP is enabled by default for all interfaces, but you must first enable CDP, using the enable lldp cdp command.

enable lldp cdp ppptemplate

Syntax ENAble LLDP CDP PPPTemplate=template

Where template is a number from 0 to 31

Description This new command enables CDP listening on interfaces that are dynamically created using the specified PPP template.

By default, when CDP has been enabled using enable lldp cdp, CDP listening is enabled for any dynamically created PPP interface.

Example To enable CDP listening for PPP template number 3, use the command:

ena lldp cdp pppt=3

Software Version 2.8.1 C613-10477-00 REV B