Allied Telesis X900-48FE Displaying SIP ALG Session Details, Firewall Policy Rules Expansion

Software Version 2.8.1 161

Command Changes

The following table summarises the new and modified commands:

CommandChange

set firewall sipalg New command.

Displaying SIP ALG Session Details

This Software Version allows you to display configuration details for the SIP ALG, and details about the SIP sessions that are using the SIP ALG on the router or switch. Use the new command:

show firewall sipalg ip=ipadd[-ipadd] [callid=call-id][counter][summary]

To show counters for the SIP sessions using SIP ALG, use the command:

show firewall sipalg counter

To reset the counters that are displayed with the show firewall sipalg counter command, use the command:

reset firewall sipalg counter

Command Changes

The following table summarises the new and modified commands:

Command	Change
reset firewall sipalg counter	New command.
show firewall sipalg	New command.
show firewall sipalg counter	New command.

Firewall Policy Rules Expansion

This Software Version increases the total number of rules and application rules (apprules) that a firewall policy can associate with an interface to 2099. In previous Software Versions the maximum number was 699.

The rules and apprules are cumulative. That is, a policy cannot assign more than 2099 rules and apprules combined to an interface.

Firewall policy rules and apprules are created with the commands add firewall policy apprule and add firewall policy rule. The range of ID numbers you can specify for a rule or apprule is unchanged from 1 to 4294967295.

Command Changes

This expansion does not affect any commands.

Software Version 2.8.1 C613-10477-00 REV B