Allied Telesis RAPIER I, X900-48FE, AT-8900 manual Set ssh server, Show loader, 192.168.1.1, Alice

152 Secure Copy (SCP) Release Note

set ssh server

Syntax SET SSH SERver [HOSTKey=key-id] [SERVERKey=key-id] [EXPirytime=0..168] [IDLEtimeout=0..4294967295] [LOGintimeout=1..600] [MAXSessions=0..6]

[SCP={ENAbledDISabled}]

Description This command modifies the configuration of the Secure Shell server. The new scp parameter allows you to enable or disable Secure Copy service.

Parameter	Description
SCP	Whether the SSH server supports SCP connections.
	Default: enabled
	ENAbled	Allows SCP connections.
	DISabled	Does not allow SCP connections.

show loader

Syntax SHow LOAder

Description This command displays defaults for the loader and the progress of the current load.

Figure 45: Example output from the show loader command

Loader Information
-----------------------------------------------------------
Defaults:
Method	SCP
File	-
Destination File....	-
Server	192.168.1.1
HTTP Proxy	-
Proxy Port	Default ( 80 )
Username	alice
Asyn	-
Destination	Flash
Delay (sec)	0
Current Load:
Method	SCP
.
.
.
Table 35: Modified parameters in output of the show loader command
Parameter	Meaning
Method	Method used to load files, one of: HTTP, SCP, TFTP, WEB, WWW,
	ZMODEM, or None.
Server	IP address or host name of the server. Used when method is set
	to SCP, TFTP or HTTP.
Username	The username set for the load or upload. This will only display if
	a username has been set.

Software Version 2.8.1 C613-10477-00 REV B