Allied Telesis AT-9900 Create switch trunk, Enable switch port vlan, Set lacp, Set switch port

28 Switching Enhancements Release Note

To view details about disabled ports for VLANs, use one of the commands:

show vlan[={vlan-name1..4094all}]

show vlan[=all]

Re-enabling a port When a port is disabled, either completely or for a specific VLAN, it remains disabled until it is manually re-enabled in any of the following ways:

■with SNMP

■as the result of a reboot

■by specifying a thrash timeout value along with the thrash action

■via the CLI

If the vlandisable thrash action has been applied, to re-enable one or more ports from VLANs to which they belong, use the command:

enable switch port={port-listall} vlan[={vlan-name1..4094all}]

If either the portdisable or linkdown thrash action has been applied, to re-enable one or more ports, use the command:

If the learndisable thrash action has been applied, the port is automatically re-enabled when the defined timeout expires. You cannot manually re-enable the port.

Port Types Limiting rapid MAC movement is supported on all port types. It is also supported on trunked ports.

Command Changes

The following table summarises the new and modified commands:

Command	Change
create switch trunk	New thrashaction parameter.
	New thrashtimeout parameter.
enable switch port vlan	New command.
enable switch port vlan	New command.
set lacp	New thrashaction parameter.
	New thrashtimeout parameter.
set switch port	New thrashaction parameter.
	New thrashtimeout parameter.
	New vlanstatustrap parameter.
set switch thrashlimit	New command.
set switch trunk	New thrashaction parameter.
	New thrashtimeout parameter.
show lacp	New address learn thrash action parameter.
	New address learn thrash timeout parameter.
show switch port	New address learn thrash status parameter.
	New address learn thrash action parameter.
	New address learn thrash timeout parameter.
	New vlan status trap parameter.

Software Version 2.8.1 C613-10477-00 REV B