Allied Telesis AT-9900, RAPIER I Reset cpu utilisation, Set system contact, Set system location

12 System Enhancements Release Note

reset cpu utilisation

Syntax RESET CPU UTIlisation

Description This command, which resets all CPU utilisation percentages, has been modified to include resetting any start and stop percentages set with the activate cpu extended command. It also removes any data captured during extended utilisation monitoring, and clears this output from the show cpu command.

Example To reset the CPU utilisation, use the command:

reset cpu util

set system contact

Syntax SET SYStem CONtact={contact-nameNONE}

The contact parameter specifies the contact name, which is:

■displayed in the output of the show system command

■stored in the MIB object sysContact

If the new option none is specified, no contact name is defined. Any existing contact name is cleared. The default is none.

set system location

Syntax SET SYStem LOCation={locationNONE}

The location parameter specifies the location of the router or switch, which is:

■displayed in the output of the show system command

■stored in the MIB object sysLocation

If the new option none is specified, no location is defined. Any existing location is cleared. The default is none.

set system name

Syntax SET SYStem NAMe={nameNONE}

The name parameter specifies the system name of the router or switch, which is:

■displayed in the output of the show system command

■displayed in the CLI prompt so you know which router or switch you are configuring

■stored in the MIB object sysName

If the new option none is specified, no name is defined. Any existing name is cleared. The default is none.

Software Version 2.8.1 C613-10477-00 REV B