Allied Telesis AT-8800 Address, Process, UDP on the router or switch, Load Balancing, Protocol

Software Version 2.8.1			79
	Table 19: New and changed parameters in the output of the show ip udp command
	Parameter Meaning
	Local	The IP address of the last interface that was used to transport UDP packets from
	Address	the router or switch, for a given process. An address of 0.0.0.0 indicates that the
		UDP session is active, but either no packets have been transmitted yet, or packets
		have been transmitted without specifying the source IP address.
	Process	The process that is using the UDP session. The following process types may use
		UDP on the router or switch:
		NTP	Time synchronisation using the Network Time Protocol
		LB	Load Balancing
		RSVP	Quality of Service determination using the Resource Reservation
			Protocol
		UPNP	Universal Plug and Play
		VOIP	Voice over IP
		L2TP	Tunnelling of PPP Link Layer data using the Layer 2 Tunnelling
			Protocol
		X25	The X25 protocol
		SYSLOG	Generation/reception of syslog type logs
		SRLP LOG	Generation/reception of logs using the Secure Router Log
			Protocol
		NETM LOG	Generation/reception of logs using the Net Manage protocol
		TFTP	Download/upload of files using the Trivial File Transfer Protocol
		SNMP	Transfer of device management data using the Simple Network
			Management Protocol
		DHCP SVR	External network node configuration by the router or switch
			acting as a Dynamic Host Configuration Protocol Server
		DHCP CLT	Communications by the router or switch when acting as a client,
			using the Dynamic Host Configuration Protocol
		BOOTP	Communications by the router or switch when acting as a BOOTP
			Relay Agent
		UDP FWD	Forwarding of UDP packets to an external device using IP Helper.
		DNS	Hostname resolution using the Domain Name System Protocol
		DNS RELAY	The relaying of DNS messages from the router or switch to an
			external host
		RIP	Routing of IP packets using the Routing Information Protocol
		IKMP	Secure communications using the Internet Security Association
			and Key Management Protocol
		IKMP NAT	Secure communications using the Internet Security Association
			and Key Management Protocol via devices configured using
			Network Address Translation
		IPSEC	Secure communications using the IP Security Protocol
		TACACS	User authentication using the Terminal Access Controller Access
			Control System protocol
		RADIUS	User authentication using the Remote Authentication Dial In User
			Service Protocol
		RAD ACC	Accounting using the RADIUS protocol

Software Version 2.8.1 C613-10477-00 REV B