Allied Telesis AT-9900, RAPIER I, X900-48FE, AT-8900, AT-8700XL manual Add l2tp ip, Disable l2tp debug

84 L2TP Enhancements Release Note

Command Reference Updates

This section describes each new command and the changed portions of modified commands and output screens. For modified commands and output, new parameters, options and fields are shown in bold.

add l2tp ip

Syntax ADD L2TP IP=ipadd[-ipadd] PPPTemplate=0..31 [NUMber={OFFONSTARTup}] [PRE13={OFFON}]

[PROXYAuth={OFFON}]

[TOSreflect={OFFONFalseTrueNOYES}]

Parameter	Description
PROXYAuth	Whether the router or switch, acting as an LNS, performs Proxy
	Authentication of the PPP user if the LAC provides Authentication
	information.
	Default: on
	ON	The LNS performs Proxy Authentication.
	OFF	The LNS does not perform Proxy Authentication.

disable l2tp debug

Syntax DISable L2TP DEBug={ALLDECodePKTSTAte} [CALL[=1..65535]TUNnel[=1..65535]]

Parameter	Description
DEBug	The debugging options to disable on the specified call or tunnel, or on
	all calls and tunnels.
	Default: no default
	DECode	Decode debugging is disabled. When enabled, this
		decodes control messages and payload message
		headers into a human-readable format.

Software Version 2.8.1 C613-10477-00 REV B