Allied Telesis AT-8700XL, RAPIER I, X900-48FE manual Show switch debug, ARL, DMA, DEV, PHY, or None

Software Version 2.8.1		43
	Table 5: New parameters in the output of the show switch command
	Parameter	Meaning
	Learn delay	Number of milliseconds that the switch waits after the last IP
		route is inserted before it starts to update the hardware
		routing system.
	Queue size	The number of entries currently in the hardware route update
		queue.
	Queue limit	The maximum number of entries that the queue can hold.
	Percent in use	The percentage of the queue limit that is currently used.
	High water mark	The highest number of messages that have been seen on the
		queue since the switch last started up.
	Queue maximum	The maximum value to which you can set the queue size. This
		depends on the amount of memory installed on the switch.
	Queue default	The default maximum number of entries in the queue. This
		depends on the amount of memory installed on the switch.
	Updating hardware (status)	The number of entries that the software has queued for
		writing into the hardware table, followed by the status. Status
		is Pending if the hardware is not currently processing queued
		routes and Active if it is currently processing the routes.

show switch debug

Syntax SHow SWItch DEBug

Figure 7: Example output from the show switch debug command

Enabled Switch Debug Modes Output Timeout

----------------------------------------------------------

DEV 16 12345

----------------------------------------------------------

Table 6: Parameters in output of the show switch debug command

Parameter	Meaning
Enabled Switch Debug Modes	Whether the debugging option for the router or switch is
	ARL, DMA, DEV, PHY, or None.

Software Version 2.8.1 C613-10477-00 REV B