Allied Telesis AT-8800, RAPIER I, X900-48FE, AT-8900, AT-8700XL, AT-9900, AT-8600 manual Show epsr debug

Ethernet Protection Switching Ring (EPSR)				show epsr debug		33
		show epsr debug
Syntax
		SHOW EPSR[={epsr-nameALL}] DEBug
Description		This command show the debugging modes enabled on each EPSR instance, or
		all EPSR instances (Figure 1-15, Table 1-4).
		Parameter	Description
		EPSR	The EPSR instance whose debugging details are displayed.
			Default: all
			epsr-name	The name of the EPSR instance. This can be a character
				string, 1 to 15 characters long. Valid characters are
				uppercase letters (A-Z), lowercase letters (a-z), digits (0-9),
				the underscore character ("_"), the hyphen character ("-").
				The epsr-name cannot be ALL.
			ALL	All EPSR instances.
		DEBug	Displays the debugging information about the specified EPSR instance, or all
			EPSR instances.
Figure 1-15: Example output from the show epsr debug command
EPSR Name	Enabled Debug Modes			Output	Timeout
--------------------------------------------------------------------------------
blue	MSG,STATE			Asyn 0 (16)	None
red	None
--------------------------------------------------------------------------------
		Table 1-4: Parameters displayed in the output of the show epsr debug command
		Parameter		Meaning
		EPSR Name		The name of the EPSR instance.
		Enabled Debug Modes		List of debug modes that are enabled for the EPSR instance.
				Possible modes are: INFO, MSG, PKT and STATE. If a no debugging
				modes are enabled, the displayed output is None.
		Output		Output device for the EPSR instance. This is only shown when a
				debug mode is enabled.
		Timeout		Time in seconds that the EPSR instance stays in debug mode. This
				is only shown when a debug mode is enabled. If no timeout value
				has been set, the displayed output is None.
				The timeout parameter is set using the enable epsr debug
				command on page 1-24
Related Commands
		show epsr